Laurent MONTOYA

En résumé

Entreprises

• Airbus Helicopters - Rotor Stress Engineer

  2015 - maintenant • Sizing mechanical rotor components under development
  • Fatigue and damage tolerance stress analysis
  • Preparing, monitoring and analysing fatigue tests of rotor parts
  • Providing structural loads limitations to ensure safety of flight tests
  • Analysing stresses and justifying resistance of rotor parts under static and fatigue loads
  • Developing structural and fatigue substantiation reports to show compliance to the EASA/FAA requirements

• Airbus Helicopters - Engineering Internship – Flight Controls & Hydraulic Engineering Department

  2015 - 2015 • Study and analysis of helicopter hydraulic systems and flight controls
  • Servo-actuators and hydraulic circuit design (Pressure, Flow rate and Temperature)
  • Verification of equipment performances and safety requirements regarding failures
  • Modelization, Simulation and Analysis of multi-domain controlled systems with AMESim® (Flight controls, Hydraulic systems, Mechanical actuators)
  • Realization of hydraulic simulation models with AMESim® for systems integration
  • Hydraulic circuit optimization to minimize pressure losses and ensure equipment performances
  • Development of Real-Time hydraulic model for Hardware-in-the-loop simulation

• Airbus Helicopters - Engineering Internship – Rotors Design Engineering Department

  2014 - 2014 • Realization of ground tests
  • Establishment of rotor digital mock-up with CATIA V5® (Skeleton & Part design – Assembly)
  • Kinematic simulation with CATIA DMU Kinematics®
  • Multibody modeling to predict the behavior of complex mechanical systems with LMS Virtual.Lab Motion®
  • Analysis of complex dynamic motions to detect potential collision between parts
  • Dynamic simulation in order to analyse and optimize the rotor behavior

Formations

• ISAE SUPAERO

  Toulouse 2014 - 2015 Advanced Master
  
  • Aerodynamics, Flight dynamics, Propulsion, Aircraft structures
  • Aviation regulation (CS/FAR 23-25)
  • Flight test experimentation (DR400, TB20)
  - Pitot static calibration, Tower Flyby
  - Controllability, Maneuverability, Stability
  - Engine failure, VMCA, Stall, Acceptance flight

• ICAI - Universidad Pontificia Comillas

  Madrid 2012 - 2013 Erasmus Exchange Program

• Institut Catholique Des Arts Et Métiers

  Toulouse 2009 - 2014 Engineer's degree

Réseau

• Arnaud DOMERC

• Benoit DAVID

• Clément GREIN

• Jérôme MARCHESSEAU

• Jonathan BERNINI

• Maxime FONTÉ

• Pierre MASCLOUX

• Steven GONCALVES DE MACEDO

• Vincent CASTANET

• Yann DUCOMMUN